Step 1

Set the stencil on the quilt to line either the top points or the bottom points with a horizontal seam of the quilt top. Mark the quilt using your preferred method, pounce pad or water/air soluble marker.

Step 2

Shift the stencil to the right lining up the left edge of the design with end of the previously marked design so it continues running in a horizontal line. If necessary the stencil can be tilted slightly to keep the design running along the chosen seam of the quilt. Mark the design. Continue this process until the design has been marked across the full width of the quilt top.

Step 3

To start the next line down, offset the template so the stars in adjacent rows are not stacked on top of each other. You can space the lines out as much or as little as you like. Mark the template.

Step 4

Shift the template to either side and realign the template per step 2 and continue marking the design across the row. Continue repeating the process for a few lines. Note: If using an air soluble pen, only mark out as many lines as you can reasonably stitch in that same day, otherwise the pen is likely to disappear before you have a chance to stitch it.

Step 5

Stitch the lines according to the red pathway in the photo below.